A ramp force is a force with defined starting and ending magnitudes and a finite duration. A ramp force may continue in a single direction, or it may start as a strong push in one direction, weaken, stop, and then strengthen in the opposite direction.
The following diagram shows a ramp force that starts at a magnitude of -5,000 and ends at 5,000:
You can apply an envelope to a ramp force in order to shape it further. The following diagram shows the effect of applying an envelope, shown in green, to the ramp force in the previous diagram.
Note that during the sustain portion of the envelope, the magnitude of the effect follows the same straight line as before the envelope was applied. For the duration of the attack and fade, the slope of the ramp is modified by the attack and fade levels.
You cannot apply an offset to a ramp force.
To create a ramp force, pass GUID_RampForce to the IDirectInputDevice2::CreateEffect method. You can also pass any other GUID obtained by the IDirectInputDevice2::EnumEffects method, provided the low byte of the dwEffType member of the DIEFFECTINFO structure (DIEFT_GETTYPE(dwEfftype)) is equal to DIEFT_RAMPFORCE. In this way you can use hardware-specific ramp forces designed by the manufacturer.
A ramp force uses a DIRAMPFORCE structure to define the starting and ending magnitude of the force, while the duration is taken from the DIEFFECT structure. Duration must never be set to INFINITE.