IDirectInputDevice2::SendForceFeedbackCommand

The IDirectInputDevice2::SendForceFeedbackCommand method sends a command to the device's force-feedback system.

HRESULT SendForceFeedbackCommand(
  DWORD dwFlags  
);
 

Parameters

dwFlags

A single value indicating the desired change in state. The value may be one of the following:

DISFFC_CONTINUE

Paused playback of all active effects is to be continued. It is an error to send this command when the device is not in a paused state.

DISFFC_PAUSE

Playback of all active effects is to be paused. This command also stops the clock on effects, so that they continue playing to their full duration when restarted.

While the device is paused, new effects may not be started and existing ones may not be modified. Doing so may result in the subsequent DISFFC_CONTINUE command failing to perform properly.

To abandon a pause and stop all effects, use the DISFFC_STOPALL or DISFCC_RESET commands.

DISFFC_RESET

The device's force-feedback system is to be put in its startup state. All effects are removed from the device, are no longer valid, and must be recreated if they are to be used again. The device's actuators are disabled.

DISFFC_SETACTUATORSOFF

The device's force-feedback actuators are to be disabled. While the actuators are off, effects continue to play but are ignored by the device. Using the analogy of a sound playback device, they are muted rather than paused.

DISFFC_SETACTUATORSON

The device's force-feedback actuators are to be enabled.

DISFFC_STOPALL

Playback of any active effects is to be stopped. All active effects will be reset, but are still being maintained by the device and are still valid. If the device is in a paused state, that state is lost.

This command is equivalent to calling the IDirectInputEffect::Stop method for each effect playing.

Return Values

If the method succeeds, the return value is DI_OK.

If the method fails, the return value may be one of the following error values:

Remarks

The device must be acquired at the exclusive cooperative level for this method to succeed.

QuickInfo

  Windows NT/2000: Requires Windows 2000.
  Windows 95/98: Requires Windows 95 or later. Available as a redistributable for Windows 95.
  Header: Declared in dinput.h.
  Import Library: Use dinput.lib.