DirectSound3DListener.SetPosition

The DirectSound3DListener.SetPosition method sets the listener's current position, in distance units. By default, these units are meters, but this can be changed by calling the DirectSound3DListener.SetDistanceFactor method.

object.SetPosition(x As Single, _
    y As Single, _
    z As Single, _
    applyFlag As CONST_DS3DAPPLYFLAGS)

Parameters

object

Object expression that resolves to a DirectSound3DListener object.

x, y, and z

Values that represent the coordinates of the listener's new position vector. Note that DirectSound may adjust these values to prevent floating-point overflow.

applyFlag

Value indicating when the setting should be applied. This value must be one of the following flags of the CONST_DS3DAPPLYFLAGS enumeration:

DS3D_DEFERRED

Settings are not applied until the application calls the DirectSound3DListener.CommitDeferredSettings method. This allows the application to change several settings and generate a single recalculation.

DS3D_IMMEDIATE

Settings are applied immediately, causing the system to recalculate the 3-D coordinates for all 3-D sound buffers.

Error Codes

If the method fails, an error is raised and Err.Number may be set to DSERR_INVALIDPARAM.

See Also

DirectSound3DListener.GetPosition