ID3DXPMesh::SetNumFaces

Sets the current level of detail to as close to the specified number of faces as possible.

HRESULT SetNumFaces(
  DWORD Faces
);

Parameters

Faces

[in] Target number of faces. This value specifies the desired change in the level of detail (LOD).

Return Values

If the method succeeds, the return value is D3D_OK.

If the method fails, the return value can be D3DERR_INVALIDCALL.

Remarks

If the number of faces is greater than the maximum number of faces, it is capped at the maximum number of faces returned by ID3DXPMesh::GetMaxFaces. If the number of faces is less than the minimum number of faces, it is capped at the minimum number of faces returned by ID3DXPMesh::GetMinFaces.

The number of faces after this call may be off by one because some edge collapse may introduce or remove one face or two. For example, if you try setting the number of faces to an intermediate value such as 5, when 4 and 6 are possible, 4 will always be the result.

Requirements

  Header: Declared in D3dx8mesh.h.
  Import Library: Use D3dx8.lib.