The following error messages are associated with the CURSORMOVE dialog box.
| minidriver name :sMult !=0 or 1 for abs. Y move | ||
| UniTool issues this message if the value entered in the sUnitMult box of the associated Units dialog box is not 0 or 1. | ||
| minidriver name :sMult !=0 or 1 for rel. Y move | ||
| UniTool issues this message if the value entered in the sUnitMult box of the associated Units dialog box is not 0 or 1. | ||
| minidriver name :sMult !=0 or 1 for rel. up Y move | ||
| UniTool issues this message if the value entered in the sUnitMult box of the associated Units dialog box is not 0 or 1. | ||
| minidriver name :sMult !=0 or 1 for linespacing Y move | ||
| UniTool issues this message if the value entered in the sUnitMult box of the associated Units dialog box is not 0 or 1. | ||