The following error messages are associated with the Printer Font Metric (PFM) dialog box.
minidriver name :Type must = 128 | ||
UniTool issues this message if the value in the Type box does not equal 128. | ||
minidriver name :Points must be > 0 | ||
UniTool issues this message if a point size value that is less than or equal to zero is entered. | ||
minidriver name :VertRes must be > 0 | ||
UniTool issues this message if a vertical resolution value that is less than or equal to zero is entered. | ||
minidriver name :HorizRes must be > 0 | ||
UniTool issues this message if a horizontal resolution value that is less than or equal to zero is entered. | ||
minidriver name :Ascent must be > 0 | ||
UniTool issues this message if a value in the Ascent box that is less than or equal to zero is entered. | ||
minidriver name :Weight should be 400 or 700 | ||
UniTool issues this message if a value in the weight box that is not equal to either 400 or 700 is entered. | ||
minidriver name :CharSet must be 0,1, or 2 | ||
UniTool issues this message if a value in the Char Set box that is not equal to 0, 1, or 2 is entered. | ||
minidriver name :AvgWidth must be > 0 | ||
UniTool issues this message if a negative value is entered in the Average Width box. | ||
Kerning Info will be lost! Continue? | ||
UniTool issues this message if kerning information will be lost. |