MCI_UNFREEZE (VIDEO OVERLAY)

This MCI command message restores motion to an area of the video buffer frozen with MCI_FREEZE. This command is part of the video overlay command set. The parameters and flags for this message vary according to the selected device.

Parameters

DWORD lParam1

The following flags apply to all devices supporting MCI_UNFREEZE:

MCI_NOTIFY

Specifies that MCI should post the MM_MCINOTIFY message when this command completes. The window to receive this message is specified in the dwCallback field of the data structure identified by lParam2.

MCI_WAIT

Specifies that the unfreeze operation should finish before MCI returns control to the application.

MCI_OVLY_RECT

Specifies that the rc field of the data structure identified by lParam2 contains a valid display rectangle. This is a required parameter.

LPMCI_OVLY_RECT_PARMS lParam2

Specifies a far pointer to a MCI_OVLY_RECT_PARMS data structure. (Devices with additional parameters might replace this data structure with a device-specific data structure.)

Return Value

Returns zero if successful. Otherwise, it returns an MCI error code.

Comments

This command applies to video overlay devices.

See Also

MCI_FREEZE