ID Number: Q48444
5.10 6.00 6.00a 6.00ax 7.00
MS-DOS
Summary:
The interrupt attribute can be applied to a function to tell the
compiler that the function is an interrupt handler.
When an interrupt function is called, all registers (except SS) are
saved on the stack. Examining the assembler code the compiler
generates for an interrupt handler could cause confusion. When
compiling without the /G1 or /G2 switch (these switches inform the
compiler to generate 186 or 286 code accordingly) the assembler code
appears as it should; however, when using one of the two
aforementioned switches, the assembler output may be deceiving in that
the registers appear as though they are not being saved on the stack
as advertised.
This potential misinterpretation results from the use of the PUSHA
instruction, which does not exist in the 8086 instruction set, but
does apply to the 80186 and more recent sets. The PUSHA instruction
pushes the general purpose registers onto the stack in the following
order: AX, CX, DX, BX, SP, BP, SI, DI. For further information
regarding the PUSHA instruction, you should consult an reference
manual for Intel's 80x86-based assembly.
More Information:
The text that follows displays two partial assembler listings of an
interrupt handler called foo. The second case demonstrates the usage
of the 186-, 286-, 386-, and 486-specific instruction PUSHA (for load
all).
/* Without G1 or G2 */
_func PROC FAR
push ax
push cx
push dx
push bx
push sp
push bp
push si
push di
push ds
push es
/* With G1 or G2 */
_func PROC FAR
pusha ; This pushes all general purpose registers
push ds ; for the 80186 processors and above.
push es
Additional reference words: 5.10 6.00 6.00a 6.00ax 7.00