ID Number: Q62505
2.00
OS/2
Summary:
If the defaults are used when installing OS/2 LAN Manager version 2.0
with an EtherLink II card, the EtherLink II card may end up using
Interrupt 3, which is the same interrupt that COM2 uses.
If you need to use the COM2 port, edit PROTOCOL.INI by hand to change
the interrupt information; otherwise, there will be a conflict with
the EtherLink II card.
Please remember that when you edit PROTOCOL.INI, you should edit the
version of PROTOCOL.INI that is in the subdirectory named in the
following line in the CONFIG.SYS file:
device=c:\lanman\drivers\protman\protman.os2
/i:c:\lanman\drivers\protman
Please note that in order for any changes to PROTOCOL.INI to take
effect, the computer must be restarted (rebooted).
The correct PROTOCOL.INI file to edit is the one that resides in the
subdirectory pointed to by the /I:C:\LANMAN\DRIVERS\PROTMAN portion
of the line listed above.
A common mistake some people make is to edit the copy of PROTOCOL.INI
that resides in C:\LANMAN\DRIVERS\ELNKII.
Additional reference words: 2.00