MCI_RESTORE
The MCI_RESTORE command copies a bitmap from a file to the frame buffer. Digital-video devices recognize this command. This command performs the opposite action of the MCI_CAPTURE command.
MCIERROR mciSendCommand(MCIDEVICEID wDeviceID, MCI_RESTORE,
DWORD dwFlags, (DWORD) (LPMCI_DGV_RESTORE_PARMS) lpRestore);
Parameters
-
wDeviceID
-
Device identifier of the MCI device that is to receive the command message.
-
dwFlags
-
MCI_NOTIFY, MCI_WAIT, or MCI_TEST. For information about these flags, see The Wait, Notify, and Test Flags.
-
lpRestore
-
Address of an MCI_DGV_RESTORE_PARMS structure.
Return Values
Returns zero if successful or an error otherwise.
Remarks
The implementation can recognize a variety of image formats, but a Windows device-independent bitmap (DIB) is always accepted.
The following additional flags apply to digital-video devices:
-
MCI_DGV_RESTORE_FROM
-
The lpstrFileName member of the structure identified by lpRestore contains an address of a buffer containing the source filename. The filename is required.
-
MCI_DGV_RESTORE_AT
-
The rc member of the structure identified by lpRestore contains a valid rectangle. The rectangle specifies a region of the frame buffer relative to its origin. The first pair of coordinates specifies the upper left corner of the rectangle; the second pair specifies the width and height. If this flag is not specified, the image is copied to the upper left corner of the frame buffer.
QuickInfo
Windows NT: Requires version 3.1 or later.
Windows: Requires Windows 95 or later.
Windows CE: Unsupported.
Header: Declared in mmsystem.h.
See Also
MCI Overview, MCI Commands, MCI_CAPTURE, MCI_DGV_RESTORE_PARMS