MCI_DELETE
The MCI_DELETE command removes data from the file. Digital-video and waveform-audio devices recognize this command.
MCIERROR mciSendCommand(MCIDEVICEID wDeviceID, MCI_DELETE,
DWORD dwFlags, (DWORD) (LPMCI_GENERIC_PARMS) lpDelete);
Parameters
-
wDeviceID
-
Device identifier of the MCI device that is to receive the command message.
-
dwFlags
-
MCI_NOTIFY, MCI_WAIT, or, for digital-video devices, MCI_TEST. For information about these flags, see The Wait, Notify, and Test Flags.
-
lpDelete
-
Address of an MCI_GENERIC_PARMS structure. (Devices with extended command sets might replace this structure with a device-specific structure.)
Return Values
Returns zero if successful or an error otherwise.
Remarks
The following flags apply to the digitalvideo device type:
-
MCI_DGV_DELETE_AT
-
A rectangle is included in the rc member of the structure identified by lpDelete. The rectangle specifies the portion of each frame to delete. When this flag is used, the frame is retained in the workspace and the area specified by the rectangle becomes black. If the flag is omitted, MCI_DELETE defaults to the entire frame and removes the frame from the workspace.
-
MCI_DGV_DELETE_AUDIO_STREAM
-
An audio-stream number is included in the dwAudioStream member of the structure identified by lpDelete. If you use this flag and also want to delete video, you must also use the MCI_DGV_DELETE_VIDEO_STREAM flag. (If neither flag is specified, data from all audio and video streams is deleted.)
-
MCI_DGV_DELETE_VIDEO_STREAM
-
A video-stream number is included in the dwVideoStream member of the structure identified by lpDelete. If you use this flag and also want to delete audio, you must also use the MCI_DGV_DELETE_AUDIO_STREAM flag. (If neither flag is specified, data from all audio and video streams is deleted.)
-
MCI_FROM
-
A starting location is included in the dwFrom member of the structure identified by lpDelete. The units assigned to the position values are specified with the MCI_SET_TIME_FORMAT flag of the MCI_SET command.
-
MCI_TO
-
An ending location is included in the dwTo member of the structure identified by lpDelete. The units assigned to the position values are specified with the MCI_SET_TIME_FORMAT flag of MCI_SET.
For digital-video devices, the lpDelete parameter points to an MCI_DGV_DELETE_PARMS structure.
The following flags apply to the waveaudio device type:
-
MCI_FROM
-
A starting location is included in the dwFrom member of the structure identified by lpDelete. The units assigned to the position values are specified with the MCI_SET_TIME_FORMAT flag of MCI_SET.
-
MCI_TO
-
An ending location is included in the dwTo member of the structure identified by lpDelete. The units assigned to the position values are specified with the MCI_SET_TIME_FORMAT flag of MCI_SET.
For waveform-audio devices, the lpDelete parameter points to an MCI_WAVE_DELETE_PARMS structure.
QuickInfo
Windows NT: Requires version 3.1 or later.
Windows: Requires Windows 95 or later.
Windows CE: Unsupported.
Header: Declared in mmsystem.h.
See Also
MCI Overview, MCI Commands, MCI_DGV_DELETE_PARMS, MCI_GENERIC_PARMS, MCI_SET, MCI_WAVE_DELETE_PARMS