[NWLink]

The parameters in this section specify settings for the IPX/SPX-compatible protocol and are valid only if protocols=nwlink is also specified in the setup script. For more information about these parameters as defined using the Network option in Control Panel, see Chapter 12, "Network Technical Discussion."

Frame Type

This parameter specifies the default frame type for IPX.

Parameter	Frame_Type
Values	0 = 802.3 1 = 802.2 2 = Ethernet II	4=Auto 5=Token ring 6=Token ring SNAP
Default	4

NetBIOS

This parameter specifies whether NetBIOS support for IPX/SPX should be installed.

Parameter	NetBIOS
Values	0 = Don't install NWNBLINK 1 = Install NWNBLINK
Default	0