ACC: "Not Enough Memory to Run SETUP.EXE" Error MessageLast reviewed: May 7, 1997Article ID: Q94928 |
The information in this article applies to:
SYMPTOMSNovice: Requires knowledge of the user interface on single-user computers. When you try to run the Microsoft Access Setup program, it fails and you receive one of the following out-of-memory error messages:
Insufficient Memory -or- Not enough memory to run SETUP.EXEWhen this error occurs, you know you have sufficient space on the disk you are installing Microsoft Access to and your AUTOEXEC.BAT file contains a valid SET TEMP statement that specifies a directory that has free disk space.
CAUSEOne cause of this error relates to an incorrect CMOS setting for the floppy disk drive from which Microsoft Access is installed.
RESOLUTIONModify the CMOS setting to correctly configure the disk drive. If you need assistance to change the settings appropriately, contact your dealer or hardware manufacturer.
MORE INFORMATIONThe error messages above can occur when you install Microsoft Access from a 1.2-megabyte disk drive and the CMOS setting for that drive indicates that it is a 360-kilobyte disk drive. |
Keywords : kberrmsg kbsetup StpOthr
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |