Description of UDP Ports

Last reviewed: September 9, 1996
Article ID: Q136403
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1
  • Microsoft Windows NT Workstation versions 3.5 and 3.51
  • Microsoft Windows NT Server versions 3.5 and 3.51
  • Microsoft TCP/IP-32 for Windows for Workgroups, versions 3.11, 3.11a, and 3.11b

SUMMARY

The User Datagram Protocol is an unreliable, connectionless oriented protocol that uses an IP address for the destination host and a port number to identify the destination application.

The UDP port number is distinct from any physical port on a computer such as a COM port or an I/O port address. The UDP port is a 16-bit address that exists only for the purpose of passing certain types of datagram information to the correct location above the transport layer of the protocol stack.

MORE INFORMATION

UDP ports are not the same as TCP ports, though TCP and UDP may use the same port number in certain instances. The UDP ports can receive more than one message at a time, and they are identified by "well known" port numbers. The following is a listing of some of the more common "well known" UDP ports:

Port   Keyword       Description
----   -----------   ------------------------------

15     NETSTAT       What is the network status

53     DOMAIN        Domain Name Server

69     TFTP          Trivial File Transfer Protocol

137    NETBIOS-NS    NetBIOS name service

138    NETBIOS-DGM   NetBIOS datagram service

161    SNMP          SNMP network monitor


The UDP specification is defined in RFC 768.

Note: The NETBIOS-NS (NetBIOS name service) port value can be configured to accommodate products from specific vendors. The Registry parameter that controls this value is NameServerPort.

For additional information on the NameServerPort parameter, please see the following article(s) in the Microsoft Knowledge Base:

   ARTICLE-ID: Q120642
   TITLE:      TCP/IP & NBT Configuration Parameters for Windows NT 3.5

REFERENCES

"Inter-Networking with Microsoft TCP/IP Using Microsoft Windows NT, Participant's Workbook," P/N 4275A, Appendix A, page 222.

"TCP/IP Illustrated, Volume 1, The Protocols," W. Richard Stevens, pp 6,7,12,13, Addison-Wesley, 1994.


KBCategory: kbnetwork
KBSubcategory: nttcp
Additional reference words: ppp endpoint connection



THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 9, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.