Using RASCOPY.BAT To Install Remote Access Service 1.1a

Last reviewed: September 9, 1996
Article ID: Q138810
The information in this article applies to:
  • Microsoft Network Client for MS-DOS, version 3.0
  • Microsoft Remote Access Service version 1.1a

The README.TXT file included with the Microsoft Network Client version 3.0 includes instructions describing how to install Remote Access Service (RAS) 1.1a. You are instructed to run the file RASCOPY.BAT after installing the Network Client software. RASCOPY.BAT will prompt you for RAS 1.1a Disks 1 and 2, even though there is only one setup disk for RAS 1.1a.

When you are prompted for RAS 1.1a Disk 2, simply press enter on the keyboard to continue without removing RAS 1.1a Disk 1. All files needed to setup RAS 1.1a are located on Disk 1.


KBCategory: kbsetup
KBSubcategory: ntras
Additional reference words: 3.00 1.10a



THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 9, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.