Cannot Log in to Windows NT Domain Over Internet connectionLast reviewed: December 30, 1997Article ID: Q170998 |
The information in this article applies to:
SUMMARYIf you are connected to the Internet through an Internet service provider (ISP), you may not be able to log in to a Windows NT Domain, or use Microsoft Networking functionality to connect to another Windows NT-based or Windows 95-based computer on the Internet. This may occur even though you may have been able to in the past.
MORE INFORMATIONA number of ISPs have disabled User Datagram Protocol (UDP) ports 137 and 138 and Transmission Control Protocol (TCP) port 139 on their routers to reduce network traffic and provide protection against out-of-band (OOB) data attacks on servers. Microsoft Networking components rely on these ports (especially TCP port 139) for NetBIOS communication. If you could previously use Microsoft Networking components over the Internet but no longer can, contact your ISP to determine if UDP ports 137 or 138 or TCP port 139 has been disabled on the ISP's routers. NOTE: This method of connecting to a Windows NT domain over the Internet is not a secure configuration and is not recommended by Microsoft. However, you can use the Point-to-Point Tunneling Protocol (PPTP) as an alternative method for communicating with your network over the Internet. PPTP is a networking technology that supports multiprotocol virtual private networks (VPNs), enabling remote users to access corporate networks securely across the Internet. Using PPTP, remote users can use Windows NT Workstation, Windows 95, and other point-to-point protocol (PPP)-enabled computers to dial into a local Internet service provider to connect securely to their corporate networks using the Internet.
REFERENCESFor more information about TCP ports, see the following RFC:
RFC-1700: Internet Assigned NumbersFor additional information about PPTP, see the following articles in the Microsoft Knowledge Base:
ARTICLE-ID: Q161410 TITLE : How to Set Up a Private Network Over the Internet Using PPTP ARTICLE-ID: Q154062 TITLE : Using PPTP Over a Non-PPTP Enabled Internet ProviderFor additional information about problems connecting to computers running Microsoft Networking components over the Internet, see the following article in the Microsoft Knowledge Base:
ARTICLE-ID: Q142027 TITLE : Troubleshooting NET USE Failure (When PING NetBIOS Name Works)For additional information about out-of-band data, see the following articles in the Microsoft Knowledge Base:
ARTICLE-ID: Q143478 TITLE : Stop 0A in TCPIP.SYS When Receiving Out Of Band (OOB) Data ARTICLE-ID: Q168747 TITLE : Update to Windows 95 TCP/IP to Address Out-of-Band IssueFor information about the types of network traffic created when you are using Microsoft Networking components (without PPTP), see the following article in the Microsoft Knowledge Base:
ARTICLE-ID: Q139608 TITLE : SMB Traffic During Windows NT Domain Logon |
Additional query words: 4.00 winnt
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |