XL Err Msg: "Setup Needs To Modify A File" During Setup

Last reviewed: March 27, 1997
Article ID: Q110074
5.00 5.00c 7.00 WINDOWS kbsetup

The information in this article applies to:

  • Microsoft Excel for Windows, versions 5.0, 5.0c
  • Microsoft Excel for Windows 95, version 7.0

SYMPTOMS

When you run the Microsoft Excel Setup program, you may receive one of the following error messages after you enter your information in the Name And Organization Information dialog box:

   Serious disk error writing to drive A:

   -or-

   Setup Needs To Modify a file on:

      A:\

   If you have locked your disk with a write-protect tab, please unlock it
   and then choose OK.

If you receive the second error message and then choose OK, you receive the same error message. If you choose Ignore, you receive the following error message:

   Could not write to the file named: 'A:\SETUP.INI'. Please verify that
   the destination drive has enough disk space."

CAUSE

During Microsoft Excel Setup, your name and organization information is written to the Setup Disk 1. You receive the error message above if Setup Disk 1 is write-protected because information cannot be written to the disk. If you are using 3.5-inch disks, the disk is write-protected if the write-protect window on the disk is open.

NOTE: It is possible for the write-protect tab to slip during the shipping and handling of your disks.

WORKAROUND

To work around this problem, do one of the following:

  • If you still have the error message on the screen:

    1. Eject Setup Disk 1 from your floppy disk drive.

    2. Close the write-protect window if you are using 3.5-inch disks or

          remove the write-protect tab if you are using 5.25-inch disks.
    

    3. Place Setup Disk 1 back in your floppy drive.

    4. In the error message dialog box, choose OK or Retry (depending on

          which error message is on the screen).
    

    -or-

  • If you have exited the Microsoft Excel Setup program:

    1. Eject Setup Disk 1 from your floppy drive.

    2. Close the write-protect window if you are using 3.5-inch disks, or

          remove the write-protect tab if you are using 5.25-inch disks.
    

    3. Place Setup Disk 1 back in the floppy drive.

    4. Run Setup again.


KBCategory: kbsetup
KBSubcategory: xlwin

Additional reference words: 5.00 5.00c 7.00 ensure b:\ full modify
setup.inf Word word6
Keywords : xlwin kbsetup
Version : 5.00 5.00c 7.00
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: March 27, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.