32-Bit ODBC Drivers in 16-Bit Windows Cause "Cannot find file"

 Last reviewed: September 12, 1996
Article ID: Q134686
The information in this article applies to:
  • Microsoft 32-Bit ODBC Drivers Kit, version 2.0
  • Microsoft Windows, version 3.11
  • Microsoft Windows for Workgroups, version 3.11

SYMPTOMS

When you attempt to run the Setup program for any of the 32-bit applications, you may receive the following error message: 

   ODBCSTP.EXE
   Cannot find file.
   Check to ensure the path and filename are correct.

CAUSE

You will receive this error message if your operating system is a 16-bit version of Microsoft Windows, and you attempt to run the Setup program for the (32-bit) applications listed at the beginning of this article.

Note that 32-bit products are not intended for use on a 16-bit operating system.

RESOLUTION

If your operating system is a 16-bit version of Microsoft Windows, install the 16-bit version of the product.

KBCategory: kbenv
KBSubcategory:

Additional reference words: ODBC ODBCSTP.EXE 2.0



THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 12, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.