XL7: Errors Inserting Data Map with Module in Step Mode

Last reviewed: September 13, 1996
Article ID: Q135093

The information in this article applies to:

Microsoft Excel for Windows 95, version 7.0

SYMPTOMS

When you attempt to insert a map on a worksheet while a module is running in the background in step mode, the following error message will be displayed:

   Microsoft Data Map is not installed. To use Data Map you must run
   Setup and choose to add Microsoft Data Map.

CAUSE

This problem occurs because the Debug window of the module sheet becomes active when you attempt to insert a map.

STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

KBCategory: kbtool
KBSubcategory:
Additional reference words: 7.00

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 13, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.