XADM: GWART Shows Site Has Routing to Itself

Last reviewed: April 21, 1997
Article ID: Q152544
The information in this article applies to:
  • Microsoft Exchange Server, version 4.0

SYMPTOMS

When you create:

  1. A Microsoft Exchange Site, site1, with a country code of "A".
2. A Microsoft Exchange Site, site2, with a country code of "B". 3. An X.400 connector from site1 to site2. 4. An X.400 connector from site2 to site1

and then you change the country code of site1 to "B" on the Site Addressing property page in the Microsoft Exchange Administrator program, the Gateway Address Routing Table (GWART) on site1 will have X.400 routing to itself. This will be over the X.400 connector from site1 to site2 and then the X.400 connector from site2 to site1. It will have a cost of 2.

STATUS

Microsoft has confirmed this to be a problem in version 4.0 of Microsoft Exchange. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.


Additional query words:
Keywords : kbbug4.00 kbusage XADM
Version : 4.0
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 21, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.