XCON: X.400 Connector Stack Property Page Behavior

 Last reviewed: February 3, 1998
Article ID: Q152934
The information in this article applies to:
  • Microsoft Exchange Server, version 4.0

SUMMARY

This article discusses the behavior of the X400 Connector Stack Property Page with respect to the Outgoing and Incoming OSI Address Information.

MORE INFORMATION

The OSI Protocol Information that is present on the Stack Property Page refers to how a remote system should be contacted (Outgoing T/S/P selectors), and how they will advertise themselves when they contact the local X.400 Connector (Incoming T/S/P selectors). These selector values always refer to the remote system. In general, a Remote X400 system will advertise itself with the same OSI information Outgoing as Incoming. Exchange stores its own "advertising name/address" in the Transport Stack page.

If the Incoming OSI Protocol Information is left blank with no values entered, then it will DEFAULT to the values specified in the Outgoing OSI Protocol Information field. That is to say, the X.400 Connector will expect to be contacted with the same T/S/P selector values (Incoming) as defined in the Outgoing.

For instance, consider the example configuration below for the following OSI address information.

OSI Protocol Information:

Outgoing: 

     T     FOREIGN
     S     FOREIGN
     P     <blank>
Incoming: 
     T     <blank>
     S     <blank>
     P     <blank>
When the X.400 Connector receives an incoming X.400 connection, it will expect the T and S Selectors to have a value of FOREIGN, and the P Selector to be blank. This is because the Incoming information is <blank>, and the default behavior is to assume the same Incoming as Outgoing if the Incoming values are not overridden.

Here is an example where the Incoming values differ from the Outgoing.

OSI Protocol Information:

Outgoing: 

     T     FOREIGN
     S     FOREIGN
     P     <blank>
Incoming: 
     T     FOREIGN
     S     <blank>
     P     <blank>
In this example, the X.400 Connector will connect to the remote X.400 entity with a T and S Selector of FOREIGN, but expects to receive only a T Selector of FOREIGN as a reply (with the S Selector being blank).

Additional query words: kbfaq
Keywords : kbbug4.00 XFOR kbusage
Version : 4.0 5.0
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: February 3, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.