DOCERR: Increasing Units Doc Error in FORTRAN Reference

 Last reviewed: July 18, 1995
Article ID: Q49894
The information in this article applies to:
  • Microsoft FORTRAN for MS-DOS, versions 5.0 and 5.1
  • Microsoft FORTRAN for OS/2, versions 5.0 and 5.1

The information on page 405, Section C.3.1.2, "Increasing Units," in the "Microsoft FORTRAN Reference" manual for version 5.0 and page 411 of "Microsoft FORTRAN Reference" manual for version 5.1 incorrectly state the following: 

   ...so that the number in the line

      _NFILE_ = 20

   equals the same value...
The correct information should be as follows: 

   ...so that the numbers in the lines

         _NFILE_  equ 20
      else
         _NFILE_  equ 40
      endif

   both equal the value...

Additional reference words: 5.00 5.10
KBCategory: kbprg kbdocerr
KBSubcategory: FORTLngIss

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: July 18, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.