CRSSPLAT Directory in Getting Started Doesn't Exist

Last reviewed: June 27, 1995
Article ID: Q101882

The information in this article applies to:

Microsoft FoxPro for Windows, versions 2.5, 2.5a, 2.6, 2.6a

There is a typographical error in the third paragraph, on page G2-12 of the "Getting Started" manual. The manual states the following:

   From the Run menu, choose Application..., then move to the
   SAMPLE\LASER\CRSSPLAT directory, select LASER.APP and choose Run.

This text is incorrect. The CRSSPLAT directory does not exist.

The manual should read:

   From the Run menu, choose Application..., then move to the
   SAMPLE\LASER\CROSPLAT directory, select LASER.APP and choose Run.

Additional reference words: FoxWin 2.50 2.50a 2.60 2.60a docerr
KBCategory: kbprg kbdocerr
KBSubcategory: FxtoolGeneral

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 27, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.