Objects Do Not Blink in FoxPro for MS-DOS Under Windows

Last reviewed: April 17, 1995
Article ID: Q104464
The information in this article applies to:
  • Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, and 2.5a

SUMMARY

Objects will not blink if FoxPro for MS-DOS is run under Windows in a window. It will blink only if it is running in full-screen mode.

MORE INFORMATION

Steps to Reproduce Problem

  1. Start FoxPro for MS-DOS under Windows in full-screen mode.

  2. In the Command window, issue the following commands:

          SET BLINK ON
          @ 2,2 SAY 'HELLO' COLOR R*/B  && IT BLINKS
    

  3. Run this session of FoxPro in a window. Note that the object stops blinking.


Additional reference words: FoxDos 2.00 2.50 2.50a
KBCategory: kbprg
KBSubcategory:


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.