FIX: ADIR() and DISPLAY MEMORY Cause "Feature Not Available"

 Last reviewed: October 14, 1997
Article ID: Q104476
2.50 WINDOWS kbenv kbprg kbfixlist kbbuglist kberrmsg

The information in this article applies to:

  • Microsoft FoxPro for Windows, version 2.5

SYMPTOMS

The following sequence of operations causes a "Feature not available" error message:

  1. Issue the following commands in the Command window: 

          =ADIR(x)
      DISPLAY MEMORY

  2. Press the ESC key (to interrupt the DISPLAY MEMORY command).

  3. Issue the following command: 

          =ADIR(x)

STATUS

Microsoft has confirmed this to be a problem in FoxPro 2.5 for Windows. This problem was corrected in FoxPro 2.5a for Windows.

Additional reference words: FoxWin 2.50 buglist2.50 fixlist2.50a errmsg err
msg 2.50a
KBCategory: kbenv kbprg kbfixlist kbbuglist kberrmsg
KBSubcategory: FxenvMemory
Solution Type : kbfix

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 14, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.