PRB: SET MOUSE Does Not Remain OFF After RUN command

Last reviewed: April 18, 1995
Article ID: Q109304

The information in this article applies to

- Microsoft FoxPro for MS-DOS, versions 2.0, 2.5x, 2.6, 2.6a

SYMPTOMS

In FoxPro versions 2.0 and later for MS-DOS, when you issue a SET MOUSE OFF command and then issue a call to MS-DOS with the RUN command, the mouse is active again when you return to the FoxPro environment.

RESOLUTION

Issue another SET MOUSE OFF command after you return to the FoxPro environment from the RUN command.

MORE INFORMATION

This problem does not occur in FoxPro versions 1.x for MS-DOS.

Additional reference words: FoxDos 2.00 2.50 2.50a 2.50b 2.60 2.60a
KBCategory: kbprg kbprb
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 18, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.