Pause Key Combination Doesn't Work in FoxPro for Mac

 Last reviewed: June 1, 1996
Article ID: Q112350
The information in this article applies to:
  • Microsoft FoxPro for Macintosh, version 2.5b
  • Microsoft Visual FoxPro for Macintosh, version 3.0b

Pressing CONTROL+NUMLOCK pauses any operation occurring in Microsoft FoxPro for MS-DOS until CONTROL+S is pressed. However, there is no corresponding key combination for Microsoft FoxPro for Macintosh.

Additional reference words: VFoxMac 3.00b FoxMac 2.50b hold stop interrupt
key keystroke
ctrl
KBCategory: kbprg
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 1, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.