PRB: Lines Overlap or Overwrite Each Other (FoxPro for MS-DOS)

Last reviewed: April 18, 1995
Article ID: Q112601

The information in this article applies to:

Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, 2.5a, and 2.5b

SYMPTOMS

When you are printing from FoxPro for MS-DOS, the lines of output overlap or overwrite each other.

CAUSE

In the Fonts section of the Printer Setup dialog box, the number of points specified for the Leading value is too small.

RESOLUTION

Increase the number of points specified for the Leading value. The Leading points value specifies the leading (the space between lines) for the entire document when a PostScript, Hewlett-Packard (HP) LaserJet IIIsi, or HP LaserJet III is chosen.

Additional reference words: FoxDos 2.00 2.50 2.50a 2.50b black lj
KBCategory: kbprg kbprb
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 18, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.