SET FIELDS TO Causes "No Fields to Process" Error

Last reviewed: June 27, 1995
Article ID: Q113279

The information in this article applies to:

Microsoft FoxPro for Windows, versions 2.6
Microsoft FoxPro for MS-DOS, versions 2.6

SUMMARY

Issuing a SET FIELDS TO command followed by a BROWSE command will cause a "No Fields to Process" error message if a SET FIELDS OFF command has not been issued first.

MORE INFORMATION

Steps to Reproduce Behavior

Type the following code in the Command Window:

   USE customer
   SET FIELDS TO city, state
   BROWSE                      &&Browse of CITY and STATE fields only
   SET FIELDS TO
   BROWSE                      &&"No Fields to Process" error will occur
   SET FIELDS OFF
   BROWSE                      &&Complete BROWSE will appear

Additional reference words: FoxDos FoxWin 2.60 SET FILES
KBCategory: kbprg
KBSubcategory: FxprgBrowse

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 27, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.