BUG: Control Panel Window Placed in Wrong Area of Screen

Last reviewed: May 16, 1996
Article ID: Q114462

The information in this article applies to:

Microsoft FoxPro for Macintosh, versions 2.5b, 2.5c

SYMPTOMS

On a multiple-monitor configuration, FoxApp will place the control panel window in the wrong area of the screen, depending on which monitor is larger than the other.

In some cases, the window is too low and too far over to the right.

RESOLUTION

To place the control window in the proper location, open the generated project file (.PJX) and reposition the windows. After you rebuild the application, the windows will be in the proper places.

STATUS

Microsoft has confirmed this to be a problem in FoxPro for the Macintosh versions 2.5b and 2.5c. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

Additional reference words: FoxMac 2.50 2.50c dual two buglist2.50
buglist2.50c
KBCategory: kbdisplay kbui kbtool kbbuglist
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 16, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.