How to Clear All Entries in the Debug Window

 Last reviewed: June 27, 1995
Article ID: Q114481
The information in this article applies to:
  • Microsoft FoxPro for Windows, versions 2.5, 2.5a, 2.5b, 2.6
  • Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, 2.5a, 2.5b, 2.6
  • Microsoft FoxPro for Macintosh, versions 2.5b, 2.5c

SUMMARY

To force FoxPro to clear all variables, expressions, and breakpoints in the Debug window, press CTRL+END while the insertion point (cursor) is in the Debug window (the Debug window has the focus).

The Debug window will be empty the next time it is opened.

MORE INFORMATION

Normally, FoxPro keeps all variables, expressions, and breakpoints entered in the Debug window, even when the Debug window is closed. As a result, when the Debug window is opened later during the same FoxPro session, all the entries are still listed. Unless you press CTRL+END, these entries are not normally cleared until you quit FoxPro.

Additional reference words: FoxMac FoxDos FoxWin 2.00 2.50 2.50a 2.50b
2.50c 2.60
KBCategory: kbprg
KBSubcategory: FxtoolDebug

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 27, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.