Contents of FoxPro 2.6a for Macintosh "CK Readme"

 Last reviewed: May 29, 1996
Article ID: Q120542
The information in this article applies to:
  • Microsoft FoxPro for Macintosh, version 2.6a

SUMMARY

Below is the complete FoxPro 2.6a for Macintosh "CK Readme" file found in the "Connectivity Kit" folder in the main FoxPro folder (usually "Microsoft FoxPro 2.6").

MORE INFORMATION

********************************************************** 

                    Release Notes for

                      Connectivity Kit
Microsoft(R) FoxPro(R) for Macintosh(R) and Power Macintosh(TM) 
           Version 2.6a Professional Edition

    (C)1994 Microsoft Corporation. All rights reserved.
**********************************************************

For installation instructions, see the "Readme Before Installation-Pro" file.

Contents

Part 1: Connecting to Data Sources Part 2: Defining Data Sources for SQL Server Part 3: "FPSQL warning 2: Failed to set general timeout" error message

Part 1: Connecting to Data Sources

In addition to the basic system requirements, you need the following hardware and software to use the Connectivity Kit:

- MacTCP driver - TCP/IP address

You must be able to connect to your data source at the network or operating system level by using TCP/IP through the MacTCP driver. Since the Macintosh does not have an equivalent of the Netlib API as on Windows, the ODBC driver supports only TCP/IP. Therefore you need to have MacTCP software in the Control Panel folder and an IP address to be able to establish connection.

Part 2: Defining Data Sources for SQL Server

To use the Connectivity Kit, you must define the specific SQL Server data source(s) to which you want to connect.

To set up data sources for SQL Server:

  1. From the Apple menu, choose Control Panels.
2. Double-click the ODBC Setup icon. 3. Choose the Setup Data Sources button. 
     The ODBC Data Sources dialog box appears.
4. Choose the Add button. 5. Select SQL Server, and then click the OK button. 
     The SQL Server Setup dialog box appears.
6. Complete the dialog box information. For more information, click 
    the Help button.

Part 3: "FPSQL warning 2: Failed to set general timeout" error message

The "FPSQL warning 2: Failed to set general timeout" error message sometimes incorrectly indicates that DbSetopt(0,"GenTimeout",250) command failed even though the result shows 1. If the result shows 1, the command was completed successfully. Ignore the error message. 

                     **End of Readme**

Additional reference words: FoxMac 2.60a
KBCategory: kbreadme
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 29, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.