How to Specify Alternate Drive Name During InstallationLast reviewed: August 28, 1995Article ID: Q120702 |
The information in this article applies to:
SUMMARYFoxPro for UNIX installs through a UNIX installation script. This article explains how you can specify an alternate device name to be used during installation.
MORE INFORMATIONBy default, FoxPro for UNIX uses /dev/install for the primary floppy disk drive. If a secondary floppy disk drive is used, /dev/install1 will probably be used during installation. If the system does not recognize one of these names during installation, see your operating system documentation so that you can provide a device name such as /dev/fd0135ds18 (for a 3.5- inch high-density primary floppy disk drive) or a UNIX raw device name (such as /dev/rfd0135ds18). For example, if the primary (boot) floppy disk drive is a high-density 3.5-inch floppy disk drive, the UNIX raw device name would be /dev/rfd0135ds18. To install FoxPro for UNIX and explicitly specify the raw device name, you would use the following command:
custom -m /dev/rfd0135ds18NOTE: custom is an SCO UNIX/XENIX installation utility.
REFERENCESSCO UNIX and SCO XENIX operating system "System Administrator's Reference"
|
Additional reference words: FoxUnix 2.60 diskette
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |