FIX: "Insufficient Memory" When Selecting Fields in RQBE

Last reviewed: September 22, 1997
Article ID: Q122360

2.60 2.60a MS-DOS kbtool kbbuglist kbfixlist kberrmsg

The information in this article applies to:

Microsoft FoxPro for MS-DOS, versions 2.60, 2.6a

SYMPTOMS

When running FoxPro for MS-DOS in standard or 16-bit mode, you receive the error message "Insufficient Memory" in RQBE after selecting the "Selected Fields" check box.

RESOLUTION

The error message only occurs in standard mode. To work around it, run FoxPro in extended mode or upgrade to FoxPro version 2.6a for MS-DOS.

STATUS

Microsoft has confirmed this to be a problem in FoxPro version 2.60 for MS-DOS. This problem was corrected in FoxPro version 2.6a for MS-DOS.

REFERENCES

Additional reference words: 2.60 2.6a buglist2.60 fixlist2.60a FoxDos
KBCategory: kbtool kbbuglist kbfixlist kberrmsg
KBSubcategory:
Solution Type : kbfix

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 22, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.