PRB: "File is in use" Message Received When Running Query

 Last reviewed: April 30, 1996
Article ID: Q127011
The information in this article applies to:
  • Microsoft FoxPro for Windows, version 2.6a

SYMPTOMS

When creating a query in RQBE that outputs to a report, you receive the message "file is in use."

CAUSE

The output is being sent to a Quick Report that has the same filename as the open report or label.

RESOLUTION

Perform one of the following:

  • Close the report or label file, and then run the query again.

    -or-

  • Use a different name for the report or label.

STATUS

This behavior is by design.

Additional reference words: FoxWin 2.60a
KBCategory: kbtool kbprb
KBSubcategory: FxtoolRqbe

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 30, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.