PRB: Setup Failure with EZ-Drive Utility

Last reviewed: September 14, 1995
Article ID: Q136728

The information in this article applies to:

Microsoft Visual FoxPro for Windows, version 3.0

SYMPTOMS

The setup program for Visual FoxPro 3.0 does not function properly when running on a computer with the following characteristics:

  - The operating system is Windows for Workgroups version 3.11.

  - 32-bit file access is on.

  - The computer has a Seagate enhanced drive (ST-31220A).

  - The EZ-Drive Utility program is installed. This program is used to
    support hard drives that are larger than 504MB.

WORKAROUND

Disable 32-bit file access in Windows for Workgroups.

STATUS

Microsoft is researching this behavior and will post new information here in the Microsoft Knowledge Base as it becomes available.

Additional reference words: 3.00 VFoxWin ez-drive wfwg failure
KBCategory: kbsetup kb3rdparty kbhw kbprb
KBSubcategory: FxsetupError

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: September 14, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.