PRB: "Error Writing Winspool.drv" During Visual FoxPro SetupLast reviewed: October 31, 1995Article ID: Q138808 |
The information in this article applies to:
SYMPTOMSThe error "Error Writing to Winspool.drv" appears while you are:
CAUSEThe LaserMaster Print Manager was installed before you ran Setup. When Visual FoxPro is installed under Windows or Windows for Workgroups, the Setup program installs Win32s. The LaserMaster drivers interfere with installing Win32s because the LaserMaster creates a WINSPOOL device. When the Setup program tries to write to Winspool.drv, it fails because it tries to write to the WINSPOOL device instead.
WORKAROUNDDisable the WINSPOOL driver before installing Visual FoxPro. Once Visual FoxPro and Win32s have been installed, you can reinstall the driver. You may need to disable the driver at all times to run Visual FoxPro. However, this should not prevent you from printing to the LaserMaster. To disable the driver, change the following three lines to comments in the [386enh] section of the System.ini file.
device = lmharold.386 device = lmmi device = lmcapThen restart your computer before you install Visual FoxPro, so the changes take effect.
STATUSMicrosoft is researching this behavior and will post new information here in the Microsoft Knowledge Base as it becomes available.
REFERENCESFor more information about this issue, please see the following article in the Microsoft Knowledge Base:
ARTICLE-ID: Q106715 TITLE : Troubleshooting Win32s Installation Problems |
Additional reference words: 3.00 VFoxWin
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |