PRB: Error Occurs when Exiting FoxPro Modal Form

Last reviewed: July 14, 1997
Article ID: Q154740
The information in this article applies to:
  • Microsoft Visual FoxPro for Windows, version 3.0b

SYMPTOMS

When you are exiting a modal form/formset with FoxPro menus created with DO FORM under Microsoft Windows version 3.1 and when Double-Byte Character Set (DBCS) are enabled, you receive the error message:

   "There is not enough memory to complete this operation."

This occurs in the release for the Far East only.

NOTE: This problem does not occur under localized Windows NT/Windows 95.

STATUS

Microsoft is researching this problem and will post new information here in the Knowledge Base as it becomes available.

MORE INFORMATION

Steps to Reproduce Behavior

  1. Create a simple modal form.

  2. Open a Menu Designer dialog box.

  3. In the Prompt column of the Menu Designer dialog box, enter appropriate double-byte characters.

  4. In the Result box, select Command.

  5. In the box to the right of the Result box, type the DO FORM form_name command.

  6. Run the menu, and open the modal form.

  7. Release the modal form and you will get a "There is not enough memory to complete this operation" error message.


Keywords : FxtoolMbuilder kbtool VFoxWin
Version : 3.0b
Platform : WINDOWS
Issue type : kbprb


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: July 14, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.