PRB: Documenting Wizard Generates Error #10

Last reviewed: November 12, 1996
Article ID: Q159281

The information in this article applies to:

Microsoft Visual FoxPro for Macintosh, version 3.0b

SYMPTOMS

After running through all the steps of the Documenting Wizard, giving the Wizard a place to put all the output reports, the Documenting Wizard generates the following error:

   Error #10 in dofoxdoc (0): Syntax error.

CAUSE

This error is caused by an apostrophe in the hard drive's name, such as "Macintosh's HD."

WORKAROUND

Temporarily rename the hard drive so it does not contain an apostrophe.

STATUS

Microsoft is researching this behavior and will post new information here in the Microsoft Knowledge Base as it becomes available.

KBCategory: kbtool kbprb
KBSubcategory: FxtoolWizother
Additional reference words: 3.00b stop fail vfoxmac

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 12, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.