PRB: Printing Unconverted 2.x Report from Preview Causes FaultLast reviewed: November 27, 1996Article ID: Q160063 |
The information in this article applies to:
SYMPTOMSIn Visual FoxPro 5.0, using the Print button in the Report Preview toolbar to print an unconverted FoxPro 2.x report causes Visual FoxPro to terminate with an Invalid Page Fault.
WORKAROUNDTo work around this problem, convert the 2.x report into Visual FoxPro 5.0 format before using the Print button in the Report Preview toolbar to print the report.
STATUSMicrosoft is researching this behavior and will post new information here in the Microsoft Knowledge Base as it becomes available.
MORE INFORMATIONVisual FoxPro 5.0 allows you to preview or print an unconverted report that was created using previous versions of FoxPro. Visual FoxPro 5.0 terminates, however, if you try to print an unconverted FoxPro 2.x report in the preview mode using the Print button on the toolbar. This behavior does not happen in Visual FoxPro 3.0 because Visual FoxPro 3.0 does not have the Print button for the report preview toolbar.
Steps to Reproduce Behavior
\\* PARTNER \\* This behavior appears to occur only with 2.x for Windows reports and \\* does not happen with FoxPro 2.x for DOS reports. \\* |
KBCategory: kbprint kbprb
© 1998 Microsoft Corporation. All rights reserved. Terms of Use. |