PRB: PC Mouse Systems Mouse Available Only in Half of Screen

Last reviewed: April 17, 1995
Article ID: Q86910

The information in this article applies to:

Microsoft FoxPro for MS-DOS, versions 1.02 and 2.0

SYMPTOMS

When you run FoxPro for MS-DOS on a system with a PC Mouse Systems optical mouse installed, the mouse is available only in the top half of the screen.

CAUSE

You have an old PC Mouse Systems mouse driver (dated earlier than December 13, 1989) installed.

RESOLUTION

Obtain and install an updated mouse driver from PC Mouse Systems.

PC Mouse Systems products are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Additional reference words: FoxDos 1.02 2.00 25 screen mode
KBCategory: kb3rdparty kbprb
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.