Using an Enhanced Display Mode with QEMM or 386MAX

Last reviewed: April 17, 1995
Article ID: Q86913
The information in this article applies to:
  • Microsoft FoxPro for MS-DOS, versions 1.02 and 2.0

To run FoxPro in an extended display mode (more than 25 lines) with either the QEMM or 386MAX extended memory manager, it is necessary to exclude the memory area used by the video board and its device driver.

Modify the corresponding line in the CONFIG.SYS file, as follows:

   QEMM:     DEVICE=QEMM.SYS RAM X=A000-C7FF
   386MAX:   DEVICE=386MAX.SYS EXCLUDE=A000-C7FF

Although the address range A000 through C7FF should be appropriate for most VGA video boards, consult the documentation for more specific information.

The QEMM and 386MAX products included here are manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.


Additional reference words: FoxDos 1.02 2.00
KBCategory: kbenv kb3rdparty
KBSubcategory:


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.