PRB: SET DISPLAY TO Resets SET MESSAGE Value

Last reviewed: April 17, 1995
Article ID: Q88139

The information in this article applies to:

Microsoft FoxPro for MS-DOS, version 2.0

SYMPTOMS

The SET DISPLAY TO <expression> command resets the SET MESSAGE value to the last line of the display. This behavior is not listed in the printed documentation.

RESOLUTION

This behavior is expected. The help file in the November 15, 1991, release of FoxPro correctly documents the SET DISPLAY TO command and how to reset the SET MESSAGE value to the last line of the display.

Additional reference words: FoxDos 2.00 RESET docerr
KBCategory: kbprg kbprb kbdocerr
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.