Error Message Appendix Should Specify 225 Work Areas

 Last reviewed: April 17, 1995
Article ID: Q95367
The information in this article applies to:
  • Microsoft FoxPro for MS-DOS, versions 2.5 and 2.5a

Appendix A of the "Developer's Guide" states that selecting a work area outside the range 1 to 25 is the cause for certain errors. The errors should specify that the range is 1 to 225 for the 32-bit version of FoxPro (the Extended version, FOXPROX.EXE) and 1 to 25 for the 16-bit of FoxPro (the Standard version, FOXPRO.EXE).

The three error messages are as follows:

  • ALIAS ["<alias>"] not found. (13)
  • ALL work areas in use. (1721)
  • Cannot access selected database. (1152)

Additional reference words: FoxDos 2.50 2.50a docerr alias not found
KBCategory: kbprg kbdocerr
KBSubcategory:

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 17, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.