Requirement of <Array1> with ACOPY() Not Documented

Last reviewed: June 27, 1995
Article ID: Q95701
The information in this article applies to:
  • Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, and 2.5a
  • Microsoft FoxPro for Windows, versions 2.5 and 2.5a

Microsoft has confirmed that the ACOPY() function was mistakenly omitted from the Array Functions table on page D9-4 of the Microsoft FoxPro version 2.0 "Developer's Guide."

In Chapter 9 of the "Developer's Guide," the "Creating Arrays" section includes a list of functions that according to the manual, will create an array. One of the functions listed is ACOPY(). Listed below is the syntax for this function:

   ACOPY(<array1>,<array2>[,<expN1>[,<expN2>[,<expN3>]]])

The documentation however, does not stress that <array1> is required. Since the purpose of this command is to copy the contents of <array1> to <array2>, <array2> will be created if and only if <array1> already exists.


Additional reference words: FoxWin FoxDos 2.00 2.50 2.50a docerr
KBCategory: kbprg kbdocerr
KBSubcategory: FxprgGeneral


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: June 27, 1995
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.