MEMLIMIT Incorrectly Documented as a SET Command

 Last reviewed: April 29, 1996
Article ID: Q97634
The information in this article applies to:
  • Microsoft FoxPro for Windows, versions 2.5 and 2.5a

Page 3-12 of the "Installation and Configuration" manual incorrectly lists the MEMLIMIT configuration setting as a SET command and states that it can be changed after starting FoxPro. However, MEMLIMIT can be specified only in the CONFIG.FPW file.

For more information on MEMLIMIT, read pages 2-7 and 3-2 through 3-4 in the "Installation and Configuration" manual.

Additional reference words: FoxWin 2.50 2.50a documentation error
docerr
KBCategory: kbprg kbdocerr
KBSubcategory: FxenvConfigfp

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: April 29, 1996
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.