PRB: SET DEVICE TO PRINTER PROMPT Does Not Open Dialog Box

• Microsoft Visual FoxPro for Windows, version 3.0
• Microsoft FoxPro for Windows, versions 2.5x, 2.6x

SYMPTOMS

Issuing the SET PRINTER ON PROMPT or SET DEVICE TO PRINTER PROMPT command immediately after issuing the same command does not produce the expected Microsoft Windows Print dialog box.

CAUSE

Once the printer has been defined, FoxPro does not display the Print dialog box again until the printer is once again in an undefined state. For example, this problem will occur if the previous print job has not yet been released by Print Manager or the network spooler.

RESOLUTION

To work around this problem, do one of the following:

• Add the command SET PRINTER TO to the end of your program so the print job will be released each time the program is run and consequently, the Print dialog box will appear every time.

  -or-

• Use the following code sequence after the print job is completed:

     SET PRINTER OFF        && disables output to the printer.
     SET PRINTER TO         && resets output to default MS-DOS PRN print
                            && utility
  
     NOTE: The SET PRINTER TO command causes a page to be ejected from
     the printer. A workaround to this behavior is not known at this
     time.
  
  

STATUS

Microsoft is researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available.

MORE INFORMATION

To reproduce the problem, run the following program twice:

   SET DEVICE TO PRINTER PROMPT
   @ 3,3 SAY 'HELLO,WORLD'
   SET DEVICE TO SCREEN

NOTE: Both jobs will print if you quit FoxPro for Windows or if you issue the SET PRINTER TO command in the Command window. Also, if the Cancel button on the prompt is selected, FoxPro ignores this action and sends the @...SAY commands to the printer anyway.

REFERENCES

"Language Reference," version 2.5, page L3-973