Invalid Operation and Inexact Result in Control Word

• Microsoft Macro Assembler for MS-DOS, versions 5.0, 5.1, 5.1a, 6.0, 6.0a, and 6.0b
• Microsoft Macro Assembler for OS/2, versions 5.1, 5.1a, 6.0, 6.0a, and 6.0b

SUMMARY

A good source of information for the 80287 Control and Status Words is the INTEL 80286 and 80287 Programmer's Reference Manual. The text below gives a brief summary of the information found in the INTEL reference concerning the Invalid Operation and Inexact Result exceptions.

MORE INFORMATION

When the 80287 processor attempts a numeric operation with invalid operands or produces a result that cannot be represented, the processor will check certain numeric exceptions. Among the exceptions checked are Invalid Operation and Inexact Result.

The 80287 reports an Invalid Operation if any of the following occurs:

   An attempt to load a register that is not empty (stack overflow).

      -or-

   An attempt to pop an operand from an empty register (stack underflow).

      -or-

   An operand is a NaN.

      -or-

   The operands cause the operation to be indeterminate (square root
      of negative number, 0/0).

The 80287's system of real numbers may be closed by either two models of infinity. The two models are projective and affine closure. The default means of closure is projective. When projective closure is selected, the NPX treats the special values +infinity and -infinity as a single unsigned infinity. In the affine mode, the NPX respects the signs of infinity. While affine mode may provide more information than projective mode, there are occasions when the sign may be misleading. Projective mode, on the other hand, provides less information, but will not be misleading.