DOCERR: MOV mem,accum and MOV accum,mem Formats Documented Wrong

 Last reviewed: November 3, 1994
Article ID: Q39372
The information in this article applies to:
  • Microsoft Macro Assembler for MS-DOS, versions 5.0, 5.1, 5.1a, 6.0, 6.0a, and 6.0b
  • Microsoft Macro Assembler for OS/2, versions 5.0, 5.1, 5.1a, 6.0, 6.0a, and 6.0b

SUMMARY

There is a documentation error on page 77 of the "Microsoft Macro Assembler 5.1 Reference" and page 112 of the "Microsoft Macro Assember Reference" that comes with MASM 6.0, 6.0a, and 6.0b. The encodings given for the following forms of the MOV instruction are incorrectly documented 

   MOV mem, accum
   MOV accum, mem
The manual describes the format of these instructions as 101000dw on those pages. The section describing the encodings (p. 27 for MASM 5.1 and p. 59 for MASM 6.0, 6.0a, 6.0b) says that a value of 1 for d (the direction flag) means that the move goes from memory to register and a 0 for d means to move from the register to memory. This results in an incorrect encoding for these forms of the MOV instruction.

MORE INFORMATION

Page 3-118 of "Intel's iAPX 86/88, 186/188 User's Manual (Programmer's Reference)" provides the correct information. 

   MOV mem, accum     should be  1010001w
   MOV accum, mem     should be  1010000w
The assember encodes these instructions using the general case 

   MOV mem, reg
   MOV accum, mem
rather than specifically using the special forms for the accumulator. The following is an example of how to encode the forms that use the accumulator by hand.

Sample Code

;Assemble options needed: none 

             .model small

             .data
myoffset     dw      23

             .code

start:       MOV     ax, @data
             MOV     ds, ax

memaccum     db      0a1h
             dw      offset myoffset

accummem     db      0a3h
             dw      offset myoffset

             MOV     ah, 4ch
             INT     21h

             END     start

Additional reference words: 5.00 5.10 5.10a 6.00 6.00a 6.00b
KBCategory: kbprg kbdocerr
KBSubcategory: MASMLngIss

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 3, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.