DOCERR: Date Format in Listing File Incorrect in MASM 6.0 Manual

Last reviewed: November 3, 1994
Article ID: Q73753
The information in this article applies to:
  • Microsoft Macro Assembler for MS-DOS, version 6.0, 6.0a, and 6.0b
  • Microsoft Macro Assembler for OS/2, version 6.0, 6.0a, and 6.0b

On page 610 of the "Microsoft Macro Assembler Programmer's Guide" version 6.0 manual, there is an example of a listing file accompanied by instructions on how to read such a file. In the header of the sample listing, the date is printed in the following format:

   MMM DD hh:mm:ss yyyy

This format was from a beta version of Macro Assembler (MASM) 6.0 that was used when the documentation was written and is not consistent with the output in the released version. In the released version, the date prints in the following format:

   MM/DD/YY hh:mm:ss


Additional reference words: 6.00 6.00a 6.00b
KBCategory: kbprg kbdocerr
KBSubcategory: MASMLngIss


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: November 3, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.